Kontakt Logg inn
Kontakt Logg inn

PicoScope 4444 HiRes Differential USB based Oscilloscope - 1000V Cat III

1000 V CAT III, passive differential 25:1 10 MHz voltage measurement probe. Supplied with detachable shrouded black and red sprung hook probe tips.

Nortelco Electronics har fått ny webside og webshop

Nortelco Electronics AS ble Adeptor AS fra 1. januar 2022, men dine kontaktpersoner er de samme! Endringen gjelder områdene Elektronikk og Automasjon, og vi har fått ny webside:

Pico is the market leader in PC Oscilloscopes — the modern alternative to the traditional benchtop oscilloscope. High-end features such as serial decoding and mask limit testing are included as standard — no more expensive "options" to pay for. We also have a long history of adding new features through free software upgrades — your PicoScope keeps getting better.
Send forespørsel
1 ukes leveringstid
Produktnummer: PQ074

The PicoScope 4444’s four inputs allow you to make true differential measurements. The maximum input range at full scale is ±50 V (±1000 V CAT III using the PicoConnect 442 probe), and the maximum common-mode range is also ±50 V (also ±1000 V with the PicoConnect 442 probe). You can set the scope to measure at resolutions of 12 or 14 bits, far better than the 8-bit resolution typical of many oscilloscopes. The deep capture memory (up to 256 million samples shared by the active channels) is another advantage, allowing you to carry out long captures without lowering the sampling rate.

The PicoScope 4444 1000 V CAT III kit is a high-resolution differential oscilloscope with three PicoConnect 442 25:1 passive differential voltage probes rated at 1000 V CAT III and one TA271 single-ended D9-BNC adaptor. The PicoScope 4444 uses specially designed passive voltage probes that have smaller and lighter interface boxes allow it to make multiple differential measurements at the same time while taking power from the Pico D9 intellient probe interface. The Pico D9 interface automatically configures the PicoScope display to the correct probe range.

The 12-bit resolution of the PicoScope 4444 offers greater vertical detail and its deeper capture memory of 256 MS gives it greater horizontal resolution. It is used in non-ground-referenced measurements, safe probing of single phase and 3-phase voltages and currents (current probes not included in this kit), measuring power drawn by mobile and IoT devices, hybrid and electric vehicle design, motor drives and inverters.The TA271 D9-BNC adaptor lets you use traditional differential voltage probes and current probes, and make single-ended measurements with a ground-referenced probe.

Picoscope 4444
4 fully differential high-impedance inputs
20 MHz bandwidth
Flexible 12 and 14-bit resolution
256 MS deep memory
Rejects common-mode noise
Interface for intelligent probes and clamps
Low-voltage probe for millivolts to 50 V (optional)
1000 V CAT III probe for high-voltage applications