Keithley 2230G 2000_2000
Keithley 2230G 2000_2000
Family picture 2230G_2000_2000
Family picture 2230G_2000_2000
2_wire_4_wire picture_2000_2000
2_wire_4_wire picture_2000_2000

Keithley 2230G-30-3, High Power, 3-Channel Programmable Power Supplies

Programmable 3-Channel Power Supply, 195 W, Two 30 V, 3 A Channels, One 5 V, 3 A Channel

NOK 11 690,- (eks. mva.)

With Keithley 2230G series you can choose between one 195 W model and two 375 W models, where the 195 W model has two 30 V, 3 A channels and one 5 V, 3 A channel, while the 375 W models have two 30 V, 6 A channels or two 60 V, 3 A channels and one 5 V, 3 A channel. All channels are independently controlled and are isolated to power a wide range of test setups USB, GPIB, and RS-232 interfaces enable complete control of the 2230G power supplies from a PC. LabView and IVI drivers facilitate instrument control, data logging, and analysis. Series 2230G power supplies can be controlled in either a semi-automated or full-automated test system with these drivers or software packages such as MatLab.
Produktnummer: 2230G-30-3
BESKRIVELSE

The Series 2230G 3-channel programmable power supplies provide up to 375 W of power in a space-saving 2U high, half-rack width enclosure to power automotive circuits, LED drivers, power supplies, power ICs, and other high-power circuits. The 2230G-30-3 offers 195 W with two 30 V, 3 A channels and a 5 V, 3 A channel. The 2230G-30-6 and the 2230-60-3 supplies output as much as 375 W. The 2230G-30-6 provides two 30 V, 6 A channels, while the 2230G-60-3 has two 60 V, 3 A channels. Both 375 W supplies have a 5 V, 3 A channel as the third channel. These three supplies are linear power supplies; thus, they are low noise supplies to have minimal impact on a device-under-test (DUT). Each channel has a rectangular output characteristic to enable obtaining the full current at the maximum voltage so that the 2230G-30-6 can supply 30 V to a 6 A load and the 2230G-60-3 can supply 60 V to a 3 A load.

SPESIFIKASJONER
Choose from one 195 W model and two 375 W models
195W, Two 30V/3A channels and one 5 V/3 A channel
All channels are independently controlled and are isolated to power a wide range of test setups
All channels have remote sensing so the programmed voltage is accurately applied to the load
Set and monitor output voltages with 0.03% basic accuracy and 1 mV resolution
Monitor load current with 0.1% basic accuracy and 1 mA resolution
Low noise, linear regulation with <1 mV rms ripple and noise
Voltage and current outputs of three channels are displayed simultaneously for immediate observation of each output state
USB, GPIB, and RS-232 interfaces and rear panel connections for automated test convenience
DOKUMENTASJON