Market demand for Distributed Resource (DR) products such as PV inverters and wind energy systems is steadily growing as the world strives for clean renewable energy sources. This demand has created a need for rigorous regulation testing to standards such IEEE 1547 / IEC 61000-3-15 / IEC 62116 ensuring proper and safe operation of on-grid products. It has become critical to manufacturers to conduct these tests to prove compliance and to relieve product liability concerns. Chroma’s new 61800 family of Grid Simulators has been designed to fulfill these test requirements by providing a full 4 quadrant, fully regenerative, grid simulator with advanced features for compliance, safety and product verification testing.
The 61800 Regenerative Grid Simulator is a full 4 quadrant, fully regenerative, AC power supply designed for common electrical product testing such as home appliances, and industrial electronics needing a programmable input source. In additional, the 61800 is design to simulate grid characteristics for testing PV inverter and on-line UPSs. As shown above, power can be both sink and source from the UUT seamlessly for to support different types of applications. In cases where the UUT sources current a detection circuit will sense the excess power and recycled it back to the grid.
The 61800 grid simulator could also meet test requirements with smart grid and EV related test applications, such as Vehicle to Grid (V2G) and Energy Storage System (ESS) testing. The 61800 regenerative grid simulator is not only limited to product development during R&D. Its extensive features are also valuable during design and quality verification as well as throughout various production stages. Using state-of-the-art digital control technology the 61800 can deliver up to 300VAC at output frequencies ranging from 30Hz to 100Hz. The AC DC feature allows for applications which require a DC offset bias.
The 61800 Regenerative Grid Simulator is capable of simulating various test conditions such as voltage distortion, frequency variation, etc., in order to meet the Micro Grid test requirements. Most importantly, the regenerative feature of 61800 series product can sink the power generated by the Discrete Generator (DG) on the micro Grid and feed the power back to the main grid. The input side of 61800 series product has been specifically designed to be isolated from the main grid. Hence additional isolation for Discrete Generator (DG) on Micro Grid is not required.
|61830 : 30kVA ; 61845 : 45kVA ; 61860 : 60kVA|
|Output voltage: 0-300V, 400V (option)|
|Output frequency: DC, 30Hz-100Hz|
|User selectable single phase or three phase output|
|Full 4 quadrant, fully regenerative up to 100% of output current rating|
|Specifically designed for PV inverter, Smart Grid and EV related test applications|
|Programmable slew rate settings for voltage and frequency|
|Programmable voltage and current limits|
|Turn on, turn off phase angle control|
|LIST, PULSE, STEP mode functions for testing Power Line Disturbance (PLD) simulation|
|Voltage dips, short interruption and voltage variation simulation|
|Harmonics, inter-harmonics waveform synthesizer|
|Comprehensive measurement capability,including current harmonics|
|Analog programmable interfaces|
|Remote interface: GPIB, RS-232, USB and Ethernet|
|Parallel output for higher power applications (Three phase only)|