Aim-TTi LDH400P Programmable Electronic DC load 400W
NOK 15 230,- (eks. mva.)
DC 400W, 600V, 16A Electronic Load USB,RS232 LAN/LXI,GPIB
4 uker leveringstid
Produktnummer:
LDH400P
BESKRIVELSE
COMPACT ELECTRONIC DC LOAD
The LDH400P is a high voltage electronic load which is suitable for testing and characterising a wide variety of dc power sources. It can be used to investigate the behaviour of many different types of power source such as PFCs, batteries and solar cells. Its wide voltage/current range, multiple operating modes and built-in transient generator give it the versatility to offer test solutions from the design laboratory through to the component test area.
CAT II (300V) RATING
The LDH400P load inputs are rated to CAT II (300V), this allows the direct testing of PFCs and mains connected power supplies to be simplified using the LDH400P by eliminating the need for an isolation transformer, saving bench space and cost.
SPESIFIKASJONER
| Wide voltage and current range, 10 to 500V and 0 to 16A | |
| 400 watts continuous dissipation at 28°C (360W at 40°C) | |
| Variable drop-out voltage for battery testing | |
| Load inputs rated to CAT II (300V) | |
| Constant current, resistance, conductance and power modes | |
| Versatile solution for direct testing of dc power sources and PFCs | |
| High resolution and accuracy for level setting | |
| High resolution backlit graphic LCD with soft key control | |
| Current monitor output for waveform viewing | |
| Analog remote control of levels and TTL control of on/off and transient switching | |
| Front and rear input terminals | |
| Built-in transient generator with variable slew | |
| Full bus control via USB, RS232, GPIB and LAN / LXI interfaces |
DOKUMENTASJON
| Datasheet: |
Aim-TTi LD Series
|